If it is defective, replace the door lock. Some models may have a shield over the connectors that can be removed by popping it out with a flathead screwdriver.
![how to install transmission and motor in whirpool washer how to install transmission and motor in whirpool washer](http://up.picr.de/11175179qg.jpg)
Disconnect the wires attached to the door lock assembly, and remove it from the washer.Reach inside the washer and carefully lift the door lock assembly off the mounting bracket. The door lock assembly sits on a mounting bracket.Remove the screws holding the door lock assembly in place.Once the ring clamp is removed, pull back the boot so that you can access the door lock.Use a flathead screwdriver to reach underneath the door seal to remove the tension and lift it off. The boot is held in place by a metal ring clamp with a spring. To access the door lock, the boot needs to be pulled back.If the door lock is broken, it is likely unrepairable and will need to be replaced.įollow these steps to check and replace the door lock: To see if the door lock is faulty due to an electrical fault, you will need to test it with a multimeter. The door lock can be checked for a mechanical fault by inspecting it closely and paying attention to it as you open and close the door. Like the lid switch on top-loader washers, if the door lock on front-loader washers is faulty, the washer will not spin. If there is no continuity, replace the lid switch with a new one.Use a multimeter to test the lid switch for continuity.On other models, the lid switch may still be attached due to wiring that will need to be disconnected. Once you remove the screws holding the lid switch in place, you should be able to pull the lid switch out from between the washer drum and top washing machine panel.If you are still unable to access the lid switch, the washer’s entire cabinet may need to be taken off. On other models, the top control panel may have to be removed to access the lid switch. Use a Phillips-head screwdriver (most models) to remove the two screws that hold the lid switch in place.Locate the two screws holding the lid switch in place (usually in the top right corner where the lid would close).Unplug the washer from the power source.If you cannot, it probably needs to be replaced.įollow these steps to check and replace the lid switch: You should also be able to hear the lid switch click when you close the lid. The lid switch on most top-loader washers can be activated manually using a screwdriver or pencil to push it to simulate the lid being closed.
![how to install transmission and motor in whirpool washer how to install transmission and motor in whirpool washer](https://photos.demandstudios.com/getty/article/171/212/87733170_XS.jpg)
The lid switch is a safety measure that prevents the washer from spinning while the lid is open. The most common reason a Whirlpool top-loader washer stops spinning is a faulty lid switch. Check to see it is not a water drainage issue that is stopping the washer from spinning. If your washer is on a lean and not level, this will affect the spin cycle.Ī water blockage, perhaps caused by a kinked external hose, can also cause the washer to stop emptying and spinning. For the same reasons, the washer itself also needs to be balanced. If there is an imbalance, perhaps because clothes have gotten caught up on one side of the drum, the motion of the washer is disrupted, which results in a subpar spin cycle. On a top-loader washer, clothes need to be placed evenly around the agitator. This guide applies to the following Whirlpool washer models: The most common causes of the issue can be fixed by following this guide. Occasionally, even the highest quality models may have an issue with the spin cycle. Their range of models features top-loaders, front-loaders, and washer-dryer combinations. Whirlpool has been making washing machines for over 100 years.